Making Chenille

The key is this fabulous chenille cutter. It easily slits flannel channels (much like an envelope opener) to create soft, plush chenille. 

The Olfa chenille cutter works for right- and left-handed stitchers, has several channel widths you can dial in, and the non-exposed blade is less lethal than a traditional rotary cutter.

Start with hooped fibrous WSS. As with most ITH designs, the first stitch shows where to place the flannel pieces. I used four pieces; one under the hoop 

and three on top, all cut to the same sizes. Five layers would probably be better. More full.

If you want to make chenille without having an embroidery program, just layer your flannel layers the same way: one face down and four face up.

The chenille ITH design creates diagonal rows of stitches. You can do the same on your own.

Dial the cutter to the proper width of your channels and insert the foot in the end of one channel. Hold the edge and slide the cutter along the channel to slice flannel.

Be careful to only cut all but the bottom layer of flannel. With ITH designs, it's easier because the WSS separates the backing from the top layers.

After slicing the layers, the ITH project stitches all layers together around the outside edge. Edges are then clipped from the outside to the stitch line, then trimmed the same amount around the outer edge. You can easily do this without a digitized program.

When washed, it turns into chenille, and the more you wash it, the fluffier it gets.

Give chenille a try!